Water softening system en ter hardness: the higher the water hardness, the greater the amount of special salt required. 4. Place the lid back on the dis- penser and turn to close. Switching off the water softening system ATTENTION! Ў Detergent may damage the water softening system. ▶ Only fill the dispenser of the wa- If you find the special salt refill indic- ator irritating, e.g. when using com- bined detergents with salt replace- ment substances, you can switch the salt refill indicator off. Note To avoid damage to the appliance, only switch off the water softening system in the following cases: Ў The water hardness is max. 26 °E ter softening system with special dishwasher salt.
Ў Special salt can damage the tub due to corrosion. ▶ To make sure that any special salt that escapes is washed out of the tub, add the special salt to the dispenser for special salt immediately before the pro- gramme starts. and you are using combined deter- gents with salt replacement sub- stances. According to manufactur- ers, combined detergents with salt replacement substances can gen- erally only be used up to a water hardness of 26 °E without adding special salt. Ў The water hardness is 0 - 8 °E. 1. Unscrew the lid of the dispenser for special salt and remove. 2. On initial start-up: Fill the dispenser right up with water. 3. Note: Only use special salt for dishwashers.
Do not use salt tablets. Do not use table salt. Add the special salt to the dis- penser. You do not need to use special salt. 1. Press . 2. To open the basic settings, press for 3 seconds. a The display shows Hxx. a The display shows . 3. Press repeatedly until the dis- play shows H00. 4. To save the settings, press a for 3 seconds. a The water softening system is switched off and the salt refill indic- ator is deactivated. Funnel 1 Fill the dispenser right up with spe- cial salt. The water in the dis- penser is displaced and forced out. 1 Depending on the appliance specifications 25