Downloaded from https://www.everyspec.com HIL-HDOK-683(AT) step 4. Problem analysis and solution - This iS the first step directed at actual ti-nt of * m-ss- It is accomplished by applying problem solving techniques as specified in 4.5. The process dispersion must represent the normal curve prior to determining if the process is capable or incapable. step 5. Inspection capability study - An ins~tion capability is a wasure of how good the inspection ~t is. The study should tKJconducted on all gages and instruments authorized per the inspection instructions and on all appraisers. The study would be ~licable to both variables ad attrititee data.
The inspection uystm ia certified only when the gages, instruments, and appraiser results are detemined to be acceptable. Standards for rating the study acceptable, marginal, or unacceptable will be issued by the Government. Step 6. hoeas capability study - A process capability study will be conduoted on all machines, fixtures, stations end operators involved in the proceaa to determine the ~bility of the process and natural and unnatural variations. It must be conducted on critical and major characteristics. This study is applicable to both variables and attributes data. When the results of the study are acceptable, the operators are certified to prform the process.
Acceptable ranges for capability ratios will be detemined by the Government. Unless otherwise specified, a process capability of 1.33 is required. step 7. Corrective and preventive action matrix - A corrective and preventive action matrix provides specific actions which should be taken to bring the process back in control. It is a document posted with each control chart that lists all known defects or out-of-ontrol conditions which can exist in the procees. With each defect or condition, action is specified to urrect the process. In essence, it is G prioritized trouble shooting ~ide.
Along with the document, a procedure should be &fined for review and ~te of the matrixas ~ defects and ablutions are identified. Step 8. Process control procedure - The process control procedure documenta the method for introducing and sustaining SPC. It establiehee responsibilities to all the various activities. It is a prwedure that nna8t be provided for each of the following processes: 36