Downloaded from https://www.everyspec.com step 11. Defect accountability - Defect aocountability ia a system for identifying and re~rting the different defect types and their sources, for example, operators, inspections, design, process, or component sources. ‘his provides opportunities for further improvement with a closed loop system. ?IIIADBK-683(AT) It creates a reporting system to further segregate problem areas. priWUY objectives are to report defecta baeed on their ~ (proceaa, ~=ta, design, or workmanship)- Step 12. Measurement of effectiveness - The mamrement of effectiveneas is utilized to assure that the desired reuults were achieved and a plan is in place to Suetai.nthe results.
This is accomplished by conducting one or more of the following audits: a. Process audit b. Product audit c. Systems audit 4.8 Utv Taz#at ~ . . The customer requirements for the outgoing quality of the final product are achieved through a technique b- as “~lity Targets,”. The technique establishes individual workstation targets for quality levels end uses the final quality target as a basis. d. Financial audit Bach process must have a quality target expressed either in percent defective reported, number of defects per KK)O units, or parts per million (Pm). Actual results should be compared against quality targets.
When actual results exceed targets in unfavorable direction, then action should be taken to bring process levels equal to or favorable to the quality target. Once WC has been implemented, the process should be improved to a level that meets cu8tomer requirements. Cus@ner quality requirement are U8ually expressed a8 the maximum fraction or percent defective allowed; that is , the number of defects per o~rtunitiea divided by the number produced. For example, a cu8t0mer may require that the product contain no more than one percent (l%) defective when shi~d.
The most cost effective way to wet this requirement is to establish quality targets for each step in the process with the final target being the Customers requirement. Then the final -twill meet the customer-a need without extensive internal inspection or 8orting. 38