MIL MIL-HDBK-683(AT) — MIL-HDBK-683(AT) Statistical Process Control (SPC) Handbook - Implementation & Evaluation PDF

Downloaded from https://www.everyspec.com FUL-HDBK+83(AT ) TABLE 11-4. to~sm~ . G - Continued. Htfall Possible Qmsequencas Wing specification limits as control limits on an X chart. Fail to detect and react to assignable causes when they occur. Not using %odif ied” control limits when applicable. ‘Modified” control limits are applied when a mess stays well within specification limits, but the average shifts outside the normal control limits. Natural control limits my cause ~ss adjustments m?en though all parts are well within specification. Not calculating the val-a of -ups and plotting them. No control whatsoever. Not taking appropriate action when a point is out of control.

Proces6 may produce many part8 out of tolerance. Not reacting to a @nt OU, of control on the R Chart if X-s still in control. Failure to detect a shift in process variability. Individual product may be outside apecificationa even though average has not shifted Not examining patterns on control charts for trends or shifts. Fail to detect and react to assignable causea when they occur. Not adjusting procem average to- specification nominal even when X Chart is in control. Unnecessary production of defective parts even thuu@ process maY & capable of meeting specifications. Not sumna.rizingdata for on-going charts to review if limits are changed.

Failure to adjust ~ts to reflect long term trends. Outdated information as to what process is currently doing. Not using separate control charts for various defect8 when the process is out of control. Inability to find real cause of defective product. Believing that a process in Statistical Control meets 8~if ication requirement. A process in Statistical Control merely means consistency over time. This stable pmce8a may or may not be meeting out8ide requirements imposed by others. 45