Chapter 5: Advanced Motherboard Setup The H8SGL-F has a 24-pin primary power supply connector (JPW1) for connection to the ATX power supply. In addition, an 8-pin processor power connector (JPW2) must also be connected to your power supply. See Section 5-9 for power connector pin definitions. Connecting Power Cables JF1 contains header pins for various front control panel connectors. See Figure 5-1 for the pin locations of the various front control panel buttons and LED indicators. Connecting the Control Panel All JF1 wires have been bundled into a single ribbon cable to simplify this connection. Make sure the red wire plugs into pin 1 as marked on the board.
The other end connects to the Control Panel PCB board, located just behind the system status LEDs on the chassis. Pins are described later in this chapter. Figure 5-1. Control Panel Header Pins Ground 20 19 NMI x (key) x (key) Power LED Vcc NIC1 (Activity) HDD LED Vcc Vcc NIC2 (Activity) Vcc OH/Fan Fail LED Power Fail LED Vcc Vcc Ground Reset Ground Power 2 1 5-3