Chapter 5: Advanced Motherboard Setup I2C to PCI-Express Slot JI 2 C1/JI 2 C2 allows you to enable the I 2 C bus to communicate with the PCI-Express slot. For the jumpers to work properly, please set both jumpers to the same setting. If enabled, both jumpers must be enabled. If disabled, both jumpers must be disabled. See the table on the right for jumper settings. VGA Enable/Disable JPG1 allows you to enable or disable the VGA port. The default position is on pins 1 and 2 to enable VGA. See the table on the right for jumper settings. LAN1/2 Enable/Disable Change the setting of jumper JPL1 or JPL2 to enable or disable the LAN1 or LAN2 Ethernet port.
See the table on the right for jumper settings. The default setting is enabled. Onboard Speaker Enable/Disable The JD1 header allows you to use either an external speaker or the internal (onboard) speaker. To use the internal onboard speaker, close pins 6 and 7 with a jumper. To use an external speaker, remove the jumper and connect the speaker wires to pins 4 (+5V) and 7 (control signal). See the table on the right for settings and the table associated with the Power LED/Keylock/ Speaker connection (previous section) for jumper settings. Note: Pins 4-7 are used only for the onboard speaker.
5-21 I2C to PCI-Express Slot Jumper Settings (JI2C1/JI2C2) Jumper Setting Definition Closed Enabled Open Disabled VGA Enable/Disable Jumper Settings (JPG1) Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled LAN1/2 En/Disable Jumper Settings (JPL1/JPL2) Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled Onboard Speaker Enable/Disable Pin Definitions (JD1) Pins Definition 6 and 7 Jump for onboard speaker 4 and 7 Attach external speaker wires