A+ Server 1122GG-TF User's Manual Installing a Hard Drive into a Drive Carrier 1. Remove the dummy drive, which comes pre-installed in the drive carrier, by removing the screws securing the dummy drive to the carrier. Note that these screws cannot be reused on the actual 2.5" hard drive. 2. Insert a drive into the carrier with the printed circuit side facing down and the connector end toward the rear of the carrier. 3. Align the drive in the carrier so that the screw holes of line up. Note that there are holes in the carrier marked “SATA” to aid in correct installation. 4. Secure the drive to the carrier with four M3 screws as illustrated below.
These screws are included in the chassis accessory box. Figure 6-3. Installing a Hard Drive into the Carrier Note : Enterprise level hard disk drives are recommended for use in Supermicro chassis and servers. For information on recommended HDDs, visit the Supermicro Web site at http://www.supermicro.com/products/nfo/files/storage/SAS-CompList. pdf 6-4