Chapter 7: BIOS Wait for F1 if Error This setting controls the system response when an error is detected during the boot sequence. When enabled, BIOS will stop the boot sequence when an error is detected, at which point you will need to press the F1 button to re-enter the BIOS setup menu. The options are Enabled and Disabled. Hit 'DEL' Message Display Use this option to Enable or Disable the "Press DEL to run setup" message in POST. Watch Dog Function This option allows the system to restart when it isn't active for more than 5-minutes. Options include Enabled and Disabled . Restore on AC Power Loss This option sets the action the system will take if there is an AC power loss to the system.
Options include Power Off, Power On or Last State . Interrupt 19 Capture Select Enabled to allow ROMs to trap Interrupt 19. The options are Enabled and Disabled. Processor & Clock Options Configuration CPU Configuration This displays static information on the Module Version, AGESA Version, Physical Count and Logical Count for the system's processor(s) and clock. CPU Information This setting is used to select which physical CPU's information to display. Options include Processor 0 or Processor 1. The information for the selected processor includes Processor number, Revision, Cache L1/L2/L3, Speed, NB CLK, Able to Change Frequency and uCode Patch Level. Note:
Zero is always the "Boot Strap Processor" or main CPU with all others being "Application Processors". GART Error Reporting This option should remain disabled for normal operation. The driver developer may enable this option for testing purposes. Options are Enabled or Disabled . 7-3