Chapter 2: Installation LAN1/2/3/4 (Ethernet Ports) Four Gigabit Ethernet ports (designated LAN1/LAN2/LAN3/LAN4) are located beside the VGA ports. Additionally, for the H8DGU-LN4F+ serverboard, there is a dedicated LAN for IPMI on top of the two rear USB ports. These Ethernet ports accept RJ45 type cables. NC indicates no connection. Unit Identifi er Button There is a Unit Identifi er (UID) button on the rear I/O of the board. There is also another UID button located on the control panel. When you push either UID button, both Rear UID and Front Panel UID Indicators will illuminate. Push either button again to turn off both indicators.
These UID indicators provide easy identifi cation of a system unit that may be in need of service. Fan Headers This motherboard has eight fan headers (Fan1 to Fan8). These 4-pin fans headers are backward compatible with 3-pin fans. However, fan speed control is available for 4-pin fans only. The fan speeds are controlled by IPMI.
See the table on the right for pin defi nitions 2-19 LAN Ports (LAN1/2/3/4) Pin Defi nition Pin# Defi nition Pin# Defi nition 1 P2V5SB 10 SGND 2 TD0+ 11 Act LED 3 TD0- 12 P3V3SB 4 TD1+ 13 Link 100 LED (Yellow, +3V3SB) 5 TD1- 14 Link 1000 LED (Yellow, +3V3SB) 6 TD2+ 15 Ground 7 TD2- 16 Ground 8 TD3+ 17 Ground 9 TD3- 18 Ground UID Button Pin Defi nitions Pin# Defi nition 1 Ground 2 Ground 3 Button In 4 Ground Fan Header Pin Defi nitions Pin# Defi nition 1 Ground 2 +12V 3 Tachometer 4 PWR Modulation