Supermicro P3TDLR — Supermicro P3TDLR Motherboard User's Manual PDF (Revision 1.0a)

Chapter 2: Installation 2-7 Connector Definitions Power Supply Connectors T able 2-1 AT X Pow er Supply 24-pin Connector Pin Definitions (AT X PO W ER) The primary power supply connec- tor on the P3TDLR is designated as ATX POWER. This is a 24-pin connector, which will also accept 20-pin power connectors, which are used with some power sup- plies. If a 24-pin connector is used, please refer to Table 2.1 for pin definitions. If a 20-pin con- nector is used, please refer to Table 2-2 for pin definitions.

T able 2-2 AT X Pow er Supply 20-pin Connector Pin Definitio ns (AT X PW R #1, AT X PW R #2) Power Supply Fail Enable/Disable T able 2-3a Pow er Fail Header Pin Definitions (JP11) Header JP11 and jumper JP12 al- low you to enable or disable the power supply fail annunciator LEDs. The normal (default) posi- tion is closed to enable power fail indications. See Table 2-3a and 2- 3b for pin definitions.

T able 2-3b O nboard VG A Enable/Disable Jum per Settings (JP12) 2-9 Pin Number Definition Pin Number Definition 1 +3.3V 2 +3.3V 3 Ground 4 +5V 5 Ground 6 +5V 7 Ground 8 PW R_OK 9 5VSB 10 +12V 11 +12V 12 +3.3V 13 +3.3V 14 -12V 15 Ground 16 PS_ON# 17 Ground 18 Ground 19 Ground 20 Res 21 +5V 22 +5V 23 +5V 24 Ground Pin Number Definition Pin Number Definition 1 +3.3V 2 +3.3V 3 Ground 4 +5V 5 Ground 6 +5V 7 Ground 8 PW -OK 9 5VSB 10 +12V 11 3.3V 12 -12V 13 Ground 14 PS-ON 15 Ground 16 Ground 17 Ground 18 -5V 19 +5V 20 +5V Pin Number Definition 1 2 3 4 P/S 1 Fail Signal P/S 2 Fail Signal P/S 3 Fail Signal Reset (from MB) Jumper Position Definition Closed Open Enabled Disabled