Supermicro P3TDLR — Supermicro P3TDLR Motherboard User's Manual PDF (Revision 1.0a)

S UPER P3TDLR User's Manual 2-10 Floppy/Hard Disk and SCSI Connections Be aware of the following when connecting the floppy and hard disk drive cables: A red mark on a wire typically designates the location of pin 1. A single floppy disk drive ribbon cable has 34 wires and two connectors to provide for two floppy disk drives. The connector with the twisted wires always connects to drive A, and the connector that does not have twisted wires always connects to drive B. Floppy Connector T able 2-28 Floppy Connector Pin Definitions (J26) The floppy connector is located on J26 and requires a 34-pin rib- bon cable for operation. See Table 2-28 for pin definitions.

T able 2-29 IDE Connector Pin Definitions (J23, J24) IDE Connectors There are no jumpers to config- ure the onboard IDE connectors J23 and J24. Refer to Table 2- 29 for pin definitions.

2-18 Pin Number Function Pin Number Function 1 GND 3 GND 5 Key 7 GND 9 GND 11 GND 13 GND 15 GND 17 GND 19 GND 21 GND 23 GND 25 GND 27 GND 29 GND 31 GND 33 GND 2 FDHDIN 4 Reserved 6 FDEDIN 8 Index- 10 Motor Enable 12 Drive Select B- 14 Drive Select A- 16 Motor Enable 18 DIR- 20 STEP- 22 W rite Data- 24 W rite Gate- 26 Track 00- 28 W rite Protect- 30 Read Data- 32 Side 1 Select- 34 Diskette Pin Number Function Pin Number Function 1 Reset IDE 3 Host Data 7 5 Host Data 6 7 Host Data 5 9 Host Data 4 11 Host Data 3 13 Host Data 2 15 Host Data 1 17 Host Data 0 19 GND 21 DRQ3 23 I/O W rite- 25 I/O Read- 27 IOCHRDY 29 DACK3- 31 IRQ14 33 Addr 1 35 Addr 0 37 Chip Select 0 39 Activity 2 GND 4 Host Data 8 6 Host Data 9 8 Host Data 10 10 Host Data 11 12 Host Data 12 14 Host Data 13 16 Host Data 14 18 Host Data 15 20 Key 22 GND 24 GND 26 GND 28 BALE 30 GND 32 IOCS16- 34 GND 36 Addr 2 38 Chip Select 1- 40 GND