Supermicro X7DA3+ — Supermicro X7DA3+ Motherboard User & Service Manual PDF

Chapter 1: Introduction Quick Reference (X7DA3+) Jumper Description Default Setting J3P 3rd PWR Failure Detect Off (Disabled) JAR Alarm Reset Off (Disabled) JBT1 CMOS Clear See Chapter 2 JCF1 Compact Card Master/Slave Select On (Master) JI 2 C1/JI 2 C2 SMB to PCI-X Slots Pins 2-3 (Disabled) JI 2 C3/JI 2 C4 SMB to PCI-E Slots Pins 2-3 (Disabled) JPS1 SAS Controller Enable Pins 1-2 (Enabled) JPL1/ JPL2 GLAN1/GLAN2 Enable Pins 1-2 (Enabled) JWD Watch Dog Pins 1-2 (Reset) Connector Description ATX PWR (JPW1) Primary 24-Pin ATX PWR Connector Aux.

PWR/CPU PWR +12V 4-pin PWR (JWP2)/+12V 8-pin PWR(JPW3) HD Audio (JC1) High Defi nition Audio Connector (JC1) Chassis Intrusion (JL1) Chassis Intrusion Header COM1 (JCOM1) COM1 Serial Port Connector Compact PWR (JWF1) Compact Card PWR Connector DIMM#1A-DIMM#4B Memory DDRII Fully Buffered DIMM Slots FAN 1-8 Fans 1-8 (Fan7: CPU Fan1, Fan8:

CPU Fan2) Floppy (J22) Floppy Disk Drive Connector FP Control (JF1) Front Control Panel Connector GLAN 1/2 (JLAN1) G-bit Ethernet Ports IDE1/IDE2(Note 1 Below)IDE1 Hard Drive (JIDE1)/Compact Flash Card (JIDE2) LE1 LED (Note 2 Below) 5V Standby PWR LED Indicator OH LED (JOH1) Overheat LED Parallel (J21) Parallel (Printer) Port PWR LED/SPKR (JD1) PWR LED(pins1-3)/SpeakerHeader (pins 4-7) PWR SMB (J17) Power System Management (I 2 C) Header PSF Power Supply Failure (See Chapter 2) SAS#0-#3,#4-#7(JSM1/2) SAS (Serial Attached SCSI) Connectors #0-#3, #4-#7 SATA#0-#5(JS1-JS6) Serial ATA Connectors #0-5 SGPIO 1/2(J29,J30) Serial General Purpose Input/Output Headers SMB (J18) System Management Bus Header Slot 7 SIM Low Profi le IPMI Connector USB 0/1/2/3 (JUSB1) Back Panel USB 0/1/2/3(JUSB1) USB 4/5 (JUSB2) Front Panel USB4/5 (JUSB2) WOL (JWOL) Wake-on-LAN Header WOR (JWOR) Wake-on-Ring Header Notes :

1.JIDE2 is for Compact Card Use only. JCF1 is used to confi gure the com- pact fl ash card as a master or a slave drive. Be sure to connect JWF1 to a power supply to provide power to the compact fl ash card. 2. When LE1 is on, the Standby Power is on. Unplug the PWR cables before changing components. 1-5