Chapter 2: Installation 3. Use your thumb and your index fi nger to hold the CPU at the North Center Edge and the South Center Edge of the CPU. North Center Edge 4. Align CPU Pin1 (the CPU corner marked with a triangle) against the socket corner that is marked with a triangle cutout. South Center Edge 5. Align the CPU key that is the semi- circle cutout below a gold dot against the socket key, the Notch on the same side of the triangle cutout on the socket. Socket Key (Socket Notch) gold dot CPU Key (semi- circle cutout) be- low the circle. 6. Once aligned, carefully lower the CPU straight down to the socket. (Do not drop the CPU on the socket.
Corner with a Do not move the CPU horizontally or triangle cutout vertically. Do not rub the CPU against CPU Pin1 the surface or against any pins of the socket to avoid damage to the CPU or the socket.) 7. With the CPU inside the socket, inspect the four corners of the CPU to make sure that the CPU is properly Load Lever installed. 8. Use your thumb to gently push the CPU in the CPU socket load lever down to the lever lock. 9. If the CPU is properly installed into the socket, the plastic PnP cap will be automatically released from the load plate when the load lever is pushed in the lever lock. Remove the PnP cap from the motherboard. ( Warning : Please save the plas- tic PnP cap.
The motherboard must ! Plastic cap is released be shipped with the PnP cap properly installed to protect the CPU socket from the load plate pins. Shipment without the PnP cap properly installed will cause damage to the socket pins.) if CPU properly installed. 2-3