Chapter 2: Installation CMOS Clear JBT1 is used to clear CMOS. Instead of pins, this "jumper" consists of contact pads to prevent the accidental clearing of CMOS. To clear CMOS, use a metal object such as a small screwdriver to touch both pads at the same time to short the connection. Always remove the AC power cord from the system before clearing CMOS. Note: For an ATX power supply, you must completely shut down the system, remove the AC power cord and then short JBT1 to clear CMOS. Watch Dog Enable/Disable Watch Dog is a system monitor that can reboot the system when a software application hangs. Close Pins 1-2 to reset the system if an applica- tion hangs.
Close Pins 2-3 to generate a non- maskable interrupt signal for the application that hangs. See the table on the right for jumper set- tings. Watch Dog must also be enabled in the BIOS. KB/ Mouse Fan6 Fan5 ATX PWR 4-Pin PWR J3P DIMM 4B (Bank 4) JPW2 JPW1 JPW3 24-Pin CPU Fan 1 Fan7 JAR J17 PSF 8-pin PWR 1 n a F USB 0/ 1/2/3 DIMM 4A (Bank 4) DIMM 3B (Bank 3) FP Control SPK PW LED COM1 Parrallel Port DIMM 3A (Bank 3) DIMM 2B (Bank 2) CPU1 1 F J 2 n a F 1 N A L J DIMM 1B (Bank 1) DIMM 2A (Bank 2) A. Clear CMOS S UPER X7DA3+ DIMM 1A (Bank 1) ® LE1 JOH1 B.
Watch Dog Enable LAN1/2 Audio CTRL CD1 Greencreek CPU2 SGPIO1 HD Audio North Bridge SGPIO2 Battery GLAN CTLR SIM LP IPMI Slot7 CPU Fan2 Slot5 PCI-33MHz Slot6 PCI-Exp x16 JBT1 A Slot4 JI 2 C3 JI 2 C4 PCI-Exp x4 South Bridge ACT4-7 Slot3 PCI-X 133 MHz JWD B ACT0-3 Slot2 JPL1 PCI-X 133 MHz JPL2 SAS Controller PXH JPS1 SAS4-7 Slot1 JWOR PCI-X 100 MHz ZCR (Green Slot) JI 2 C1 JI 2 C2 USB4/5 SAS0-3 SATA1 SATA0 JL1 SMB SATA2 SATA4 SATA5 SATA3 JWOL JS10 Fan4 2-25 Watch Dog Jumper Settings (JWD) Jumper Setting Defi nition Pins 1-2 Reset (default) Pins 2-3 NMI Open Disabled Compact Flash IDE1 Fan8 Fan3 1 Floppy IO S