Chapter 2: Installation Compact Flash Master/Slave Select Compact Flash Card Master/ Slave Select A Compact Flash Master/Slave Select Jumper is located at JCF1. Close this jumper to enable Compact Flash Card. For the Compact Flash Card or the Compact Flash Jumper (JCF1) to work properly, you will need to connect the Compact Flash Card power cable to JWF1 fi rst. Refer to the board layout below for the location. Jumper Defi nition Open Slave Closed Master Alarm Reset If three power supplies are installed and Alarm Reset (JAR) is enabled, the system will notify you when any of the three power modules fails.
Connect JAR to a micro-switch to enable you to turn off the alarm that is activated when a power module fails. See the table on the right for pin defi nitions.
2-27 Alarm Reset Pin Setting Defi nition Pin 1 Ground Pin 2 +5V JPW2 JPW1C FaP nU 1J3P JJ A17 R PSF B 8-pin JP PW WR 3 M ouseKB/ PW RFan6 Fan5 FA aT nX 7P2 W44 -- RPi Pi nn 4) (Bank 4B DIMM Fan1 1/2/3USB 0/ 4) (Bank 4A DIMM Control C O M 1 3) (Bank 3B DIMM FJF P 1 3) (Bank 3A DIMM C PU 1 tallel 2) (Bank 2B DIMM Fan2 JLAPP Na o1r rr 2) (Bank 2A DIMM LEDSPK 1) (Bank 1B DIMM PW 1) (Bank 1A DIMM LE1 U P E R X 7 D A 3 +® S LAN1/2 CD1 G reencreek C PU 2 Audio SGPI HD CTRL Audio N orth B ridge SGPI SIM LP IPMI Slot7 A PCI-33MHz C TLRG LA N Slot5 JB T1 I- xx 61pEPCSlot6 B attery CPU CoFl mo JCF1JW F1 p I p ap Dcy t E 1Flas FFF haaa nnn 382 BridgeSouth x4Slot4JIC2 3 JIC2 4 BIO S PCI-Exp ACT4-7 JW D zSlot3 PC I-X 133 M H ACT0-3 SAS Controller PC I-X 133 M H zSlot2J J PXHPP LL 21 SA S4-7 JPS1 Slot)Slot1JW O R JIC2 1 JIC2 2 PC I-X 100 M H z ZC R (G reen U SB 4/5 SA S0- SM B SA TA 4 SA TA 5 SS AA TT AA 101LJ SA TA 2 JW O LSA TA 3 an4 A.
Compact Flash Master/ Slave Select B. Alarm Reset JOH1 O1 O2 3