Chapter 6: Advanced Chassis Setup SATA Drives: Because of their hotswap capability, you do not need to access the inside of the chassis or power down the system to install or replace SATA drives. Accessing the Drive Bays Proceed to the next step for instructions. Note: The operating system you use must have RAID support to enable the hot-swap capability of the drives. There is no onboard RAID support DVD Drive: For installing or removing a DVD drive, you must gain access to the inside of the server by removing the top cover of the chassis. Proceed to the "DVD Drive Installation" section in this chapter for instructions. Note that only a "slim" DVD drive will fit into the A+ Server 1012A-MTF.
A DVD drive does not come standard with the system. The SATA drives plug into a backplane that provides power, drive ID and bus termi nation. A RAID controller can be used with the backplane to provide data security for the drives. The backplane is already preconfigured, so there are no jumpers or switches present on it. Hard Drive Installation Note : Use caution when working around the SATA backplane. Do not touch the backplane with any metal objects and make sure no ribbon cables touch the backplane. Note : Enterprise level hard disk drives are recommended for use in Supermicro chassis and servers.
For information on recommended HDDs, visit the Supermicro Web site at http://www.supermicro.com/products/nfo/files/storage/SAS-1-Com pList-110909.pdf The hard drives are mounted in drive carriers to simplify their installation and removal from the chassis. These carriers also help promote proper airflow for the system. For this reason, even empty carriers without drives installed must remain in the chassis. 6-1