Supermicro SuperServer 1015B-M3 — Supermicro SuperServer 1015B-M3 User's Manual PDF (Revision 1.0)

Chapter 5: Advanced Serverboard Setup 5-5 Installing the Processors and Heatsinks Avoid placing direct pressure to the top of the processor package. Always remove the power cord fi rst before adding, removing or changing any hardware components. ! Notes: Always connect the power cord last and remove it before adding, remov- ing or changing any components. Make sure to install the processor into the CPU socket before you install the CPU heatsink. Intel's boxed Xeon CPU package contains the CPU fan and heatsink assembly. If you buy the CPUs separately, use only Intel-certifi ed heatsinks and fans.

Inspect the Xeon 3200 CPU socket and make sure that the CPU plastic cap is in place and none of the socket pins are bent. Otherwise, contact the retailer im- mediately. All graphics shown in this manual are for reference only. The components that came with your serverboard may or may not look exactly the same as the pictures shown in this manual. Installing the CPU A black PnP cap is attached to 1. the load plate to protect the CPU socket. Press the load lever down Load lever and away from the retention clasp to release the load plate from its locked position. PnP cap Gently lift the load lever to release 2. the load plate. Use your thumb and your index 3.

fi nger to hold the CPU at opposite sides. Align pin1 of the CPU (the corner 4. marked with a triangle) with the notched corner of the CPU socket. Load plate released Find the corner of the CPU that 5. has a semi-circle cutout below a gold dot (CPU key). This corner should be aligned with the cutout on the socket (socket key). 5-5