Supermicro SuperServer 1018L-MP — Supermicro SuperServer 1018L-MP User's Manual PDF Download

SUPERSERVER 1018L-MP User's Manual Front Panel Audio Control Header When front panel headphones are plugged in, the back panel audio output is disabled. This is done through the FP Audio header (AUDIO FP). If the front panel interface card is not connected to the front panel audio header, jumpers should be installed on the header pin pairs: 1-2, 5-6, and 9-10. If these jumpers are not installed, the back panel line out connector will be disabled and microphone input Pin 1 will be left floating, which can lead to excessive back panel microphone noise and cross talk.. Speaker (JD1) On the JD1 header, Pins 3-4 are used for the internal speaker.

Close Pins 3-4 with a cap to use the onboard speaker. If you wish to use an external speaker, attach the external speaker cable to Pins 1-4. Internal Speaker/Buzzer (SP1) The internal speaker on SP1 can be used to provide audible indications for various beep codes. 5-18 High Definition Fron Panel Audio Pin# Signal 1 MC L _ 2 AUD GND _ 3 MC R _ 4 FP Audio-Detect _ 5 Line 2 R _ _ 6 SENSE1 RETURN _ 7 AUD GND _ 8 Key 9 Line 2 L _ _ 10 SENSE2 RETURN _ Speaker Connector Pin Definitions Pin Setting Definition Pins 3-4 Internal Speaker Pins 1-4 External Speaker Internal Buzzer Pin Definition Pin# Definitions Pin 1 Pos. (+) Beep In Pin 2 Neg. (-) Alarm Speaker