Supermicro SuperServer 1019S-M2 — 6.3 Advanced Setup Configurations

SuperServer 1019S-M2 User's Manual Chapter 6: BIOS DMI/OPI Configuration Program PCIe ASPM After OPROM The following DMI information will display: PCIe ASPM, the Active State Power Management for PCI-Express slots, is a power management protocol used to manage power consumption of serial-link devices installed on PCI-Exp slots during a prolonged off-peak time. If this item is set to Enabled, PCI-E ASMP will be programmed after OPROM. If this item is set to Disabled, the PCI-E ASPM will be programmed before OPROM. The options are Disabled and Enabled. DMI DMI VC1 Control Use this feature to enable or disable DMI Virtual Channel 1. The options are Enabled and Disabled .

Memory Configuration DMI VCm Control The following memory information will display: Use this feature to enable or disable the DMI Virtual Channel map. The options are Enabled and Disabled. Memory RC Version Memory Frequency DMI Link ASPM Control Use this feature to set the ASPM (Active State Power Management) state on the SA (System Agent) side of the DMI Link. The options are Disabled and L1 . Total Memory VDD DMI Extended Sync Control DIMMA1 Use this feature to enable or disable the DMI extended synchronization. The options are Disabled and Enabled. DIMMA2 DMI De-Emphasis Control DIMMB1 Use this feature to configure the De-emphasis control on DMI. The options are -6dB and -3.5dB .

DIMMB2 PEG Port Configuration Memory Timings (tCL-tRCD-tRP-tRAS) Maximum Memory Frequency SLOT6 Max Link Speed Use this feature to set the maximum memory frequency for onboard memory modules. The options are Auto , 1067, 1200, 1333, 1400, 1600, 1800, 1867, 2000, 2133, 2200, 2400, 2600, 2667, 2800, 2933, 3000, and 3200. This feature allows the user to select PCI-E support for the device installed on SLOT6. The options are Auto , Gen 1, Gen 2, and Gen 3. SLOT6 Max Payload Size Max TOLUD Use this feature to select the PEG0 maximum payload size. The options are Auto , 128 TLP, and 256 TLP.

This feature sets the maximum TOLUD value, which specifies the "Top of Low Usable DRAM" memory space to be used by internal graphics devices, GTT Stolen Memory, and TSEG, respectively, if these devices are enabled. The options are Dynamic , 1 GB, 1.25 GB, 1.5 GB, 1.75 GB, 2 GB, 2.25 GB, 2.5 GB, 2.75 GB, 3 GB, 3.25 GB, and 3.5 GB. SLOT6 Power Limit Value Use this feature to set the upper limit on the power supplied by the PCIE slot. Press "+" or "-" on your keyboard to change this value. The default setting is 75 . Energy Performance Gain SLOT6 Power Limit Scale Use this feature to enable or disable the energy performance gain. The options are Disabled and Enabled.

Use this feature to select the scale used for the slot power limit value. The options are 1.0x , 0.1x, 0.01x, and 0.001x. 71 70