Supermicro SuperServer 1019S-M2 — 6.3 Advanced Setup Configurations

SuperServer 1019S-M2 User's Manual Chapter 6: BIOS TPM State Intel I210 Gigabit Network Connection - 00:25:90:5D:39:AF This feature changes the TPM State. The options are Disabled and Enabled. Note: The system will restart to change the TPM State. NIC Configuration Pending TPM operation Link Speed Use this item to schedule a TPM-related operation to be performed by a security device for system data integrity. Your system will reboot to carry out a pending TPM operation. The options are None and TPM Clear. Use this feature to specify the port speed used for the selected boot protocol. The options are Auto Negotiated , 10 Mbps Half, 10 Mbps Full, 100 Mbps Half, and 100 Mbps Full.

Wake On LAN Device Select Select Enabled for Wake_On_LAN support, which will allow the system to "wake up" when an onboard LAN device receives an incoming signal. The options are Disabled and Enabled . Use this feature to select the TPM version. TPM 1.2 will restrict support to TPM 1.2 devices. TPM 2.0 will restrict support for TPM 2.0 devices. Select Auto to enable support for both versions. The default setting is Auto . The following are informational status messages that indicate the current TPM State: Blink LEDs TPM Enabled Status Use this feature to identify the physical network port by blinking the associated LED. Use the keyboard to select a value.

TPM Active Status UEFI Driver TPM Owner Status This item displays the UEFI driver version. TXT Support Adapter PBA Intel TXT (Trusted Execution Technology) helps protect against software-based attacks and ensures protection, confidentiality and integrity of data stored or created on the system. Use this feature to enable or disable TXT Support. The options are Disabled and Enabled. This item displays the Processor Bus Adapter (PBA) model number. The PBA number is a nine digit number (i.e., 010B00-000) located near the serial number. Device Name iSCSi Configuration This item displays the adapter device name.

iSCSI Initiator Name Chip Type This feature allows the user to enter the unique name of the iSCSI Initiator in IQN format. Once the name of the iSCSI Initiator is entered into the system, configure the proper settings for the following items. This item displays the network adapter chipset name. PCI Device ID This item displays the device ID number. Add an Attempt PCI Address Delete Attempts This item displays the PCI address for this computer. PCI addresses are 3 two-digit hexadecimal numbers. Change Attempt order Link Status This item displays the connection status. MAC Address This item displays the MAC address for this computer. Mac addresses are 6 two-digit hexadecimal numbers. 85 84