Chapter 3 Motherboard Connections PCI-E Slot SMB Enable (JI 2 C1/JI 2 C2) JI 2 C1 and JI 2 C2 are used to enable PCI-E SMB (System Management Bus) support to improve system management for the onboard PCI-E slot. Both jumpers must be set to the same setting. Management Engine (ME) Recovery Use JPME1 to select ME Firmware Recovery mode, which will limit resource allocation for essential system operation only in order to maintain normal power operation and management. In the single operation mode, online upgrade will be available via Recovery mode. Watch Dog JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system when a software application hangs.
Jumping pins 1-2 will cause Watch Dog to reset the system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for the application that hangs. Watch Dog must also be enabled in BIOS. The default setting is Reset. Note: When Watch Dog is enabled, you need to write your own application software to disable it. 35 SMB to PCI-E Slots (JI2C1/JI2C2) Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled (Default) ME Recovery Jumper Settings Jumper Setting Definition Pins 1-2 Normal (Default) Pins 2-3 ME Recovery Watch Dog Jumper Settings Jumper Setting Definition Pins 1-2 Reset (Default) Pins 2-3 NMI Open Disabled