S UPER S ERVER 1027B-MTF User's Manual 5-2 Processor and Heatsink Installation When handling the processor package, avoid placing direct pressure on the label area of the fan. ! Notes: Always connect the power cord last and always remove it before adding, re- moving or changing any hardware components. Make sure that you install the processor into the CPU socket before you install the CPU heatsink. If you buy a CPU separately, make sure that you use an Intel-certifi ed multi- directional heatsink only. Make sure to install the serverboard into the chassis before you install the CPU heatsinks.
When receiving a serverboard without a processor pre-installed, make sure that the plastic CPU socket cap is in place and none of the socket pins are bent; otherwise, contact your retailer immediately. Refer to the Supermicro web site for updates on CPU support. Installing an LGA 1356 Processor 1. Press the socket clip to release the load plate covering the CPU socket from its locked position. 2. Gently lift the socket clip to open the load plate. 3. Hold the plastic cap at its north and south center edges to remove it from the CPU socket. 4. After removing the plastic cap, hold the CPU at the north and south center edges with your thumb and index fi nger,. 5-2