Supermicro SuperServer 1027B-MTF — Supermicro SuperServer 1027B-MTF User's Manual PDF (1U Rackmount Server)

Chapter 5: Advanced Serverboard Setup 5-3 Connecting Cables Now that the processors are installed, the next step is to connect the cables to the serverboard. These include the data (ribbon) cables for the peripherals and control panel and the power cables. Connecting Data Cables The cables used to transfer data from the peripheral devices have been carefully routed in preconfi gured systems to prevent them from blocking the fl ow of cooling air that moves through the system from front to back. If you need to disconnect any of these cables, you should take care to reroute them as they were originally after reconnecting them (make sure the red wires connect to the pin 1 locations).

If you are confi guring the system, keep the airfl ow in mind when routing the cables. The following data cables (with their serverboard connector locations noted) should be connected. See the serverboard layout diagram in this chapter for connector locations. Control Panel cable (JF1, see next page) SATA cables (I-SATA0 ~ I-SATA3, SCU-SATA0 ~ SCU-SATA3) SGPIO cable (T-SGPIO1 and SCU-SGPIO to SATA backplane) Connecting Power Cables The X9DBL-iF has a 24-pin primary power supply connector designated "JPW1" for connection to the ATX power supply. Connect the appropriate connector from the power supply to JPW1 to supply power to the serverboard.

See the Connector Defi nitions section in this chapter for power connector pin defi nitions. In addition, your power supply must be connected to the 8-pin Processor Power connectors at JPW2 and JPW3. Connecting the Control Panel JF1 contains header pins for various front control panel connectors. See Figure 5-1 for the pin locations of the various front control panel buttons and LED indicators. Please note that even and odd numbered pins are on opposite sides of each header. All JF1 wires have been bundled into single keyed ribbon cable to simplify their con- nection.

Connect one end of this cable to JF1 and the other end to the Control Panel printed circuit board, located just behind the system status LEDs in the chassis. See the Connector Defi nitions section in this chapter for details and pin descrip- tions of JF1. 5-5