Supermicro SuperServer 1027B-MTF — Supermicro SuperServer 1027B-MTF User's Manual PDF (1U Rackmount Server)

Chapter 5: Advanced Serverboard Setup 5-5 Installing Memory Note: Check the Supermicro web site for recommended memory modules. CAUTION Exercise extreme care when installing or removing DIMM modules to prevent any possible damage. Installing DIMMs Insert the desired number of DIMMs into the memory slots, starting with slot P1- DIMM#1A. 1. Push the release tabs outwards on both ends of the DIMM slot to unlock it. 2. Align the key on the DIMM module with the receptive point on the slot. 3. Use two thumbs together to press both ends of the module straight down into the slot until the module snaps into place. 4.

Press the release tabs to the lock positions to secure the DIMM module into the slot. See Figure 5-4. Memory Support The X9DBL-iF supports up to 192 GB of ECC DDR3-1600/1333/1066/800 RDIMMs/ LRDIMMs (RDIMM = Registered DIMMs, LRDIMM = Reduced Load DIMMs) or up to 48GB of ECC UDIMMs (Unregistered DIMMs). Figure 5-4. Installing DIMM into Slot Notch Notch To Install: Insert module vertically and press down until it snaps into place. Pay attention to the alignment notch at the bottom. Front View To Remove: Use your thumbs to gently push the release tabs near both ends of the module. This should release it from the slot. Note: Notch should align with the receptive key point on the slot.

Release Tab Release Tab Top View of DDR3 Slot 5-7