Chapter 5: Advanced Motherboard Setup Universal Serial Bus (USB) Two USB 2.0 ports (USB 0/1) are located on the I/O back panel. In addition, a Type-A connector is also located on the motherboard to provide front USB 3.0 support (USB 2). (Cables are not included.) See the tables on the right and below for pin defi nitions. Ethernet Ports Two Gigabit Ethernet ports (LAN1 and LAN2) are located on the I/O back panel on the motherboard. These Ethernet ports support 1GbE LANs on the motherboard. In addition, an IPMI-dedicated LAN is located above USB 0/1 ports on the back panel. All of these ports accept RJ45 cables. Please refer to the LED Indicator section for LAN LED information.
Infi niBand Connector (Optional for X10DRT-LIBF/LIBQ) An optional Infi niBand connector with FDR/QDR support is located on the I/O back panel on the X10DRT-LIBF/LIBQ. This connector provides data interconnectivity within the same computer and among different computers. It is used in High- Performance Computing (HPC) platforms featuring very high throughput with very low latency. See the layout below for the location.
5-19 Back Panel USB 0/1 (2.0) Pin Defi nitions Pin# Defi nition Pin# Defi nition 1 +5V 5 +5V 2 USB PN1 _ 6 USB PN0 _ 3 USB PP1 _ 7 USB PP0 _ 4 Ground 8 Ground Type A USB 2 (3.0) Pin Defi nitions Pin# Description 1 VBUS 2 SSRX- 3 SSRX+ 4 Ground 5 SSTX- 6 SSTX+ 7 GND DRAIN _ 8 D- 9 D+