Chapter 3: System Interface Chapter 3 System Interface 3-1 Overview There are LEDs on the control panels and on the hard drive carriers to keep you constantly informed of the overall status of the system as well as the activity and health of specifi c components. There are also two buttons on each control panel. This chapter explains the meanings of all LED indicators and the appropriate re- sponse you may need to take. Note that the server has two control panels, one for each serverboard (node) installed in the system. This allows each node to be controlled independently of the other. 3-2 Control Panel Buttons There are two push-buttons located on each control panel:
a power on/off button and a UID button. Power This is the main power button, which is used to apply or turn off the main system power only to the node it is connected to. Depressing this button removes the main power but keeps standby power supplied to the serverboard. Therefore, you must unplug the AC power cord from any external power source before servicing. This button has an LED built into it, which will illuminate when its node is powered on. UID Depressing the UID (unit identifi er) button illuminates an LED on both the front and rear of the chassis for easy system location in large stack confi gurations. The LED will remain on until the button is pushed a second time.
Another UID button on the rear of the chassis serves the same function. This button has an LED built into it, which will illuminate when either the front or rear UID button is pushed. 3-1