Appendix A: BIOS Error Beep Codes Appendix A BIOS Error Beep Codes During the POST (Power-On Self-Test) routines, which are performed each time the system is powered on, errors may occur. Non-fatal errors are those which, in most cases, allow the system to continue the boot-up process. The error messages normally appear on the screen. Fatal errors are those which will not allow the system to continue the boot-up procedure. If a fatal error occurs, you should consult with your system manufacturer for possible repairs. These fatal errors are usually communicated through a series of audible beeps.
The numbers on the fatal error list (on the following page) correspond to the number of beeps for the corresponding error. All errors listed, with the exception of Beep Code 8, are fatal errors. A-1 AMIBIOS Error Beep Codes A-1 Beep Code Error Message Description 1 beep Refresh Circuits have been reset (Ready to power up) 5 short beeps and 1 long beep Memory error No memory detected in the system 5 beeps No Con-In or No Con-Out devices Con-In: USB or PS/2 keyboard, PCI or Serial Console Redirection, IPMI KVM or SOL Con-Out:
Video Controller, PCI or Serial Console Redirection, IPMI SOL 1 beep per device Refresh 1 beep for each USB device X9 IPMI Error Codes 1 continuous beep System overheat System overheat