SUPERSERVER 2028TP-DECR/DECTR/DECFR User's Manual A reliable ground must be maintained at all times. To ensure this, the rack itself should be grounded. Particular attention should be given to power supply connections other than the direct connections to the branch circuit (i.e. the use of power strips, etc.). Reliable Ground 2-5 Installing the System into a Rack This section provides information on installing the 2028TP-DECR/DECTR/DECFR into a rack unit with the rails provided. There are a variety of rack units on the market, which may mean that the assembly procedure will differ slightly from the instructions provided.
You should also refer to the installation instructions that came with the rack unit you are using. NOTE: This rail will fi t a rack between 26.5" and 36.4" deep. Warning: Do not pick up the server with the front handles. They are designed to pull the system from a rack only. Stability Hazard: The rack stabilizing mechanism must be in place, or the rack must be bolted to the fl oor before you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip over. Warning: Slide rail mounted equipment is not to be used as a shelf or a work space. The chassis package includes two rail assemblies in the rack mounting kit. Each assembly consists of three sections:
An inner chassis rail which secures directly to the chassis, an outer rail that secures to the rack, and a middle rail which extends from the outer rail (see Figure 2-1). These assemblies are specifi cally designed for the left and right side of the chassis. Identifying the Sections of the Rack Rails 2-4