Chapter 5: Advanced Serverboard Setup 5-5 Installing Memory Installing Memory 1. Insert each memory module vertically into its slot, paying attention to the notch along the bottom of the module to prevent inserting the module incorrectly (see Figure 5-2). 2. Install starting with slot P1/DIMMA1. 3. Gently press down on the memory module until it snaps into place. 4. With two CPUs installed, repeat step 2 to populate the CPU2 DIMM slots. 5. See the tables that follow for details on populating the DIMM slots. Note: It is highly recommended that you remove the power cord from the system before installing or changing memory modules.
Please refer to our website for memory that has been tested on the X10DRT-P/PIBF/PT serverboard. For best performance, use memory modules of the same type and speed in the same bank. Memory Support The X10DRT-P/PIBF/PT has sixteen (16) DIMM slots supporting up to 1 TB of LRDIMM (Load Reduced DIMM) or 512 GB of RDIMM (Registered DIMM) DDR4-2133/1866/1600 MHz registered ECC memory. Note: Check the Supermicro website (www.supermicro.com) for the latest memory support information. Figure 5-2. DIMM Installation Release Tab Socket Key Release Tab 5-9