Chapter 5: Advanced Serverboard Setup Populating DDR4 RDIMM/LRDIMM ECC Memory Modules 5-6 Adding PCI Expansion Cards The 2028TP-DECR/DECTR/DECFR can accommodate two standard size and one low-profi le expansion cards card per node. Installing an Expansion Card 1. After powering down a node, pull it out from the chassis. 2. Remove the PCI slot shield from the slot you wish to populate. 3. Fully seat the card into the slot, pushing down with your thumbs evenly on both sides of the card. 4. Finish by using a screw to secure the top of the card shield to the chassis.
The PCI slot shield protects the serverboard and its components from EMI and aid in proper ventilation, so make sure it is always in place. 5. Insert the node back into the chassis and power it on. 5-11 E5-2600 v3 Series Processor Memory Support Type Ranks Per DIMM & Data Width Memory Capacity Per DIMM (See the Note below) Speed (MT/s) and Voltage Validated by Slot per Channel (SPC) and DIMM Per Channel (DPC) 1 Slot Per Channel 2 Slots Per Channel 1DPC 1DPC 2DPC 4GB 8GB 1.2v 1.2v 1.2v RDIMM SRx4 8GB 16GB 2133 2133 1866 RDIMM SRx8 4GB 8GB 2133 2133 1866 RDIMM DRx8 8GB 16GB 2133 2133 1866 RDIMM DRx4 16GB 32GB 2133 2133 1866 LRDIMM QRx4 32GB 64GB 2133 2133 2133 Note:
For detailed information on memory support and updates, please refer to the SMC Recommended Memory List posted on our website at http://www.supermicro.com/support/ resources/mem.cfm.