SUPERSERVER 2028TP-DECR/DECTR/DECFR User's Manual LAN Ports Enable/Disable JPL1 enables or disables the LAN1/2 Ethernet ports on the serverboard. See the table on the right for jumper settings. The default setting is Enabled. Watch Dog Enable/Disable Watch Dog (JWD1) is a system monitor that can reboot the system when a software application hangs. Close pins 1-2 to reset the system if an application hangs. Close pins 2-3 to generate non-maskable interrupt signals for the application that hangs. See the table on the right for jumper settings. Watch Dog must also be enabled in the BIOS. VGA Enable Jumper JPG1 allows the user to enable the onboard VGA connectors.
The default setting is pins 1-2 to enable the connection. See the table on the right for jumper settings. BMC Enable Jumper JPB1 allows you to enable the onboard BMC (Baseboard Management Controller) to provide IPMI 2.0/KVM support on the serverboard. Be sure to remove the power cord before closing pins 2-3 to disable the BMC. See the table on the right for jumper settings.
5-18 LAN Enable (JPL1) Jumper Settings Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled Watch Dog (JWD1) Jumper Settings Jumper Setting Defi nition Pins 1-2 Reset Pins 2-3 NMI Open Disabled VGA Enable (JPG1) Jumper Settings Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled BMC Enable (JPB1) Jumper Settings Jumper Setting Defi nition Pins 1-2 BMC Enabled Pins 2-3 Normal