SUPERSERVER 2028TP-DECR/DECTR/DECFR User's Manual 6-11 Drive Bay Installation/Removal Accessing the Drive Bays SATA Drives: You do not need to access the inside of the chassis or remove power to replace or swap SATA drives. Proceed to the next step for instructions. You must use standard 1" high, SATA drives in the system. Note: Refer to the following FTP site for RAID setup guidelines: ftp://ftp.supermicro. com/driver/SAS/LSI/LSI_SAS_EmbMRAID_SWUG.pdf > and Supermicro's web site for additional inmformation http://www.supermicro.com/support/manuals/ >. The SC217 chassis contains two individual motherboards in separate node drawers. Each motherboard node controls a set of twelve hard drives.
Note that if a motherboard node drawer is pulled out of the chassis, the hard drives associated with that node will power down as well. Figure 6-16. Hard Drives and the Corresponding Motherboards MB: B MB: A 1 A 1 B 6-14 Serverboard Drawer Locations in the Chassis Serverboard A controls HDDs A1 through A12 Serverboard B controls HDDs B1 through B12