Chapter 6: Advanced Chassis Setup 6-6 Power Supply The 5017C-LF has a single 200 watt power supply. This power supply has the capability of operating at a 100 or 240 input voltage. If the power supply unit fails, the system will shut down and you will need to replace the power supply unit. Unplug all power leading to the chassis. 1. Replacing the Power Supply Disconnect all wiring from the power supply. 2. Remove the four screws which secure the power supply to the chassis. The 3. two front mounting screws are located on the front of the power supply.
The two rear mounting screws are accessed on the underside of the chassis and extend upwards through the mounting holes to hold the power supply in place. Set the screws aside for later use. Remove the power supply from the chassis. 4. Align the mounting holes on the power supply with the mounting holes in the 5. chassis and reattach the power supply to the chassis using the four screws which were previously set aside Connect the chassis wiring to the power supply. 6. Finish by reconnecting the AC power cord and depressing the power button 7. on the front of the system. 6-7