Supermicro SuperServer 5017C-TF — Supermicro SuperServer 5017C-TF User's Manual PDF Download

Chapter 2: Server Installation 2-6 Checking the Drive Bay Setup Next, you should check to make sure the peripheral drives and the SATA drives have been properly installed and all essential connections have been made. For servicing the DVD-ROM and fl oppy drives, you will need to remove the top chassis cover. Checking the Drives The Serial ATA disk drives can be installed and removed from the front of the chassis without removing the top chassis cover. Depending upon your system's confi guration, your system may have one or two Serial ATA drives already installed. If you need to install Serial ATA drives, please refer to the appropriate section in Chapter 6.

Checking the Airfl ow Airfl ow is provided by two 10-cm input fans. The system component layout was carefully designed to promote suffi cient airfl ow through the small 1U rackmount space. Also note that all power and data cables have been routed in such a way that they do not block the airfl ow generated by the fans. Providing Power The last thing you must do is to provide input power to the system. Plug the power cord from the power supply unit into a high-quality power strip that offers protection from electrical noise and power surges. It is recommended that you use an uninterruptible power supply (UPS). 2-9