Chapter 4: Motherboard Connections SuperServer 5019S-ML User's Manual Power LED/Speaker TPM/Port 80 Header Pins 1-3 of JD1 are used for power LED indication and pins 4-7 are for the speaker. Please note that the speaker connector pins (4-7) are used with an external speaker. If you wish to use the onboard speaker, you should close pins 6-7 with a jumper. A Trusted Platform Module (TPM)/Port 80 header is located at JTPM1 to provide TPM support and Port 80 connection. Use this header to enhance system performance and data security.
SGPIO Headers The SGPIO (Serial General Purpose Input/Output) headers are used to communicate with the enclosure management chip on the backplane and support the SATA ports. Standby Power The Standby Power header is located at JSTBY1 on the motherboard. NC = No Connection Disk-On-Module Power Connector Two power connectors for SATA DOM (Disk On Module) devices are located at JSD1/JSD2. Connect appropriate cables here to provide power support for your Serial Link DOM devices. Internal Speaker/Buzzer The Internal Speaker (SP1) can be used to provide audible notifications using various beep codes.
41 40 Trusted Platform Module Header Pin Definitions Pin# Definition Pin# Definition 1 LCLK 2 GND 3 LFRAME# 4 5 LRESET# 6 +5V 7 LAD3 8 LAD2 9 +3.3V 10 LAD1 11 LAD0 12 GND 13 SMB CLK _ 14 SMB DAT _ 15 +3V Stdby 16 SERIRQ 17 GND 18 CLKRUN# 19 LPCPD# 20 LDRQ# PWR LED Connector Pin Definitions Pin Setting Definition 1 JD1 PIN1 _ 2 FP PWR LED _ _ 3 FP PWR LED _ _ Speaker Connector Pin Definitions Pin Setting Definition 4 P5V 5 Key 6 R SPKPIN N _ _ 7 R SPKPIN _ I-SGPIO 1/2 I-SGPIO1 Ports 2-4 I-SGPIO2 Ports 5-7 SGPIO Header Pin Definitions Pin# Definition Pin# Definition 1 NC 2 NC 3 GND 4 Data 5 Load 6 GND 7 Clock 8 NC Wake-On-LAN Pin Definitions Pin# Definition 1 +5V Standby 2 Ground 3 Wake-up DOM Power Pin Definitions Pin# Definition 1 5V 2 Ground 3 Ground Internal Buzzer Pin Definitions Pin# Polarity Definition 1 Pos (+) Beep In 2 Neg (-) Alarm Speaker