Supermicro SUPERSERVER 5028TK-HTR/HTTR — 7-3 Advanced Setup Configurations

SUPERSERVER 5028TK-HTR/HTTR User's Manual EMS Console Redirection Settings (Available when EMS Console Redirection is enabled) Use this feature to specify how the host computer will exchange data with the client computer, which is the remote computer used by the user. Out-of-Band Management Port The feature selects a serial port in a client server to be used by the Windows Emergency Management Services (EMS) to communicate with a remote host server. The options are COM1 (Console Redirection) and SOL (Console Re­ direction). Terminal Type Use this feature to select the target terminal emulation type for Console Redirec­ tion. Select VT100 to use the ASCII character set.

Select VT100+ to add color and function key support. Select ANSI to use the extended ASCII character set. Select VT-UTF8 to use UTF8 encoding to map Unicode characters into one or more bytes. The options are ANSI, VT100, VT100+, and VT-UTF8 . Bits Per Second This item sets the transmission speed for a serial port used in Console Redirec­ tion. Make sure that the same speed is used in both host computer and the client computer. A lower transmission speed may be required for long and busy lines. The options are 9600, 19200, 57600, and 115200 (bits per second). Flow Control Use this item to set the flow control for Console Redirection to prevent data loss caused by buffer overflow.

Send a "Stop" signal to stop data-sending when the receiving buffer is full. Send a "Start" signal to start data-sending when the receiving buffer is empty. The options are None, Hardware RTS/CTS, and Software Xon/Xoff. The following settings will be displayed: Data Bits, Parity, Stop Bits 7-32