Preface Preface About This Manual This manual is written for professional system integrators and PC technicians. It provides information for the installation and use of the SuperServer 5028TK-HTR/HTTR. Installation and maintenance should be performed by experienced technicians only. The SuperServer 5028TK-HTR/HTTR is a high-end server based on the SC827HQ+-R2K04BP2 2U rackmount chassis and the single processor K1SPi/K1SPi-T serverboard. All models have four serverboard nodes with three hot-swap Hard Disk Drives (HDD) for each per node. Manual Organization Chapter 1:
Introduction The first chapter provides a checklist of the main components included with the server system and describes the main features of the K1SPi/K1SPi-T serverboard and the SC827HQ+-R2K04BP2 chassis. Chapter 2: Server Installation This chapter describes the steps necessary to install the SuperServer 5028TK-HTR/HTTR into a rack and check out the server configuration prior to powering up the system. If your server was ordered without processor and memory components, this chapter will refer you to the appropriate sections of the manual for their installation. Chapter 3:
System Interface Refer here for details on the system interface, which includes the functions and information provided by the control panel on the chassis as well as other LEDs located throughout the system. Chapter 4: Standardized Safety Warnings You should thoroughly familiarize yourself with this chapter for a general overview of safety precautions that should be followed when installing and servicing the SuperServer 5028TK-HTR/HTTR. Chapter 5: Advanced Serverboard Setup Chapter 5 provides detailed information on the K1SPi/K1SPi-T serverboard, including the locations and functions of connections, headers and jumpers.
Refer to this chapter when adding or removing processors or main memory and when reconfiguring the serverboard. iii