SUPERSERVER 5028TK-HTR/HTTR User's Manual 6-7 Removing and Installing the Backplane The SC827HQ+ chassis backplane is located behind the hard drives and in front of the front system fans. In order to change jumper settings on the backplane, it may be necessary to remove the backplane from the chassis. Removing the Backplane Removing the Backplane from the Chassis 1. Power down and unplug the system from any power source. 2. Remove the chassis cover. 3. Disconnect the cabling to the backplane. 4. Remove all of the hard drive trays from the front of the chassis. 5. Remove the four upper screws at the top of the backplane, indicated by the 6.
Loosen the three screws in the spring bar, located on the floor of the chassis, arrows below. indicated by the arrows below (Figure 6-6). Figure 6-6. Removing the Screws at the Top of the Backplane 1 5 6-8