Supermicro SUPERSERVER 5028TK-HTR/HTTR — Installing the Backplane

SUPERSERVER 5028TK-HTR/HTTR User's Manual Installing the Backplane into the Chassis (Figure 6-9) Installing the Backplane 1. Ensure that all of the hard drive trays have been removed from the bays in the front of the chassis and that the spring bar has been loosened as directed in the previous section. 2. Secure the side mounting bracket to the backplane with the two screws provided. 3. Slide the backplane into the chassis at a slight angle, pushing it up against the side of the chassis. 4. Ease the backplane forward, against the front of the chassis. This will aid in 5. Align the mounting holes in the backplane with the holes in the chassis. the alignment of the mounting holes.

Replace the four screws at the top of the backplane and the screw on the side of the chassis. 6. Adjust the spring bar, then tighten the spring bar screws in the floor of the chassis. 7. Replace the side screw in the side of the chassis 8. Reconnect all cables and return the hard drive trays to their bays in the front of the chassis. Figure 6-9. Installing the Backplane 1 2 1 3 1 4 6-10