Supermicro SUPERSERVER 5028TK-HTR/HTTR — Accessing the Drive Bays

SUPERSERVER 5028TK-HTR/HTTR User's Manual Installing the Hard Drive (Figure 6-17) 1. Install a new drive into the carrier with the printed circuit board side facing down so that the mounting holes align with those in the carrier. 2. Secure the hard drive by tightening all six (6) screws. 3. Use the open handle to replace the drive tray into the chassis. Make sure the close the drive tray handle. Figure 6-17. Installing the Hard Drive SATA Hard Drive 2 2 1 2 Drive Tray Caution: Enterprise level hard disk drives are recommended for use in Supermicro chassis and servers.

For information on recommended HDDs, visit the Supermicro website at http://www.supermicro.com/products/nfo/files/storage/SAS-CompList.pdf 6-18