Chapter 1: Introduction Node Front View 3 2 UID LED 4 Node 1 Power LED Warning LED 4 1 Master Power Button Node 2 Power LED 5 KVM Port 6 KVM Switch/LED 7 IPMI LAN 8 Node 1 LAN Ports Node 2 LAN Ports 8 Figure 1-3. Single Node Tray t C 11 Node Pair Features Item Feature Description 1 Power button Power button for the node pair--press to power on; press for four seconds to power down 2 UID LED When blue, node pair is identified 3 Warning LED Solid Red: Overheat condition detected Fast Blinking Red (1 Hz): Fan failure detected Slow Blinkng Red (0.25 Hz): Power failure detected 4 Node Power LEDs (one for each node) Green: Node is operating normally Amber: Node is in standby mode Off:
Node is off 5 KVM port Connect the adapter to this port to provide two USB2 ports, one COM port, and one VGA port 6 KVM Switch/LED The KVM switch controls which node is connected to the KVM port. The LED in the switch indicates green for node 1 or amber for node 2. 7 IPMI LAN Port Dedicated LAN port for IMPI connection 8 LAN Four LAN ports, two for node 1 and two for node 2