Chapter 3: Maintenance and Component Installation Chapter 3 Maintenance and Component Installation This chapter provides instructions on installing and replacing main system components. To prevent compatibility issues, only use components that match the specifications and/or part numbers given. 3.1 Removing Power Each motherboard sled can be removed independently of the others, so most maintenance tasks can be completed removing power from only the affected sled. Power Down a Node Depress the motherboard sled power button for four seconds to power down the two nodes in that sled.
Power Down the Entire System Use the following procedure to ensure that power has been removed from the entire system. This is necessary only when removing non hot-swap components such as the backplane. 1. Use the operating system to power down the system. 2. After the system has completely shut-down, disconnect the AC power cords from the power strip or outlet. 3. Disconnect the power cords from the rear of the chassis. 21