Chapter 3: Maintenance and Component Installation Removing a Sled The system features twelve removable sleds. Each sled contains a motherboard hosting two nodes and two to four storage drives. The sleds allow access to the motherboards and drives. Removing a Sled from the System 1. Power-down the node pair on the sled by pressing the power button. 2. Press and hold down the release tab on the top front of the sled. 3. Use the sled handle to pull it from the system. Release Tab Handle Figure 3-2. Removing a Sled Note: Except for short periods of time while swapping sleds, do not operate the server with the sled bays empty.
In the event of a node failure, remove the sled of the failed node and replace it with a dummy node that was included with the system. 23