Chapter 3: Maintenance and Component Installation Installing 2.5" Solid State Drives An optional kit is required to install four 2.5" SDDs (MCP-220-93903-0N bracket). 1. Remove the sled from the chassis. 2. Insert two SSDs with the printed circuit board side facing downward so that the mounting holes in the drive align with those in the bottom of the sled. 3. Secure the drives to the sled with the screws included with the drive. 4. Place the other two SSDs onto the optional bracket with the printed circuit board side facing downward and secure with screws as shown below. 5.
Secure the bracket with the SSDs installed directly above the drives already mounted in the sled with the screws provided as shown below. 6. Return the node sled into the bay in the chassis. 4 5 Figure 3-7. Installing 2.5" Drives 31