Chapter 6: BIOS P-State Coordination This feature allows the user to change the P-State (Power-Performance State) coordination type. P-State is also known as "SpeedStep" for Intel processors. Select HW_ALL to change the P-State coordination type for hardware components only. Select SW_ALL to change the P-State coordination type for all software installed in the system. Select SW_ANY to change the P-State coordination type for a software program in the system. The options are HW_All, SW_ALL, and SW_ANY. Energy Efficient P-State Select Enable to support power-saving mode for P-State. The options are Disable and Enable.
Boot Performance Mode This feature allows the user to select the performance state that the BIOS will set before the operating system handoff. The options are Max Performance and Max Efficient. Turbo Mode Select Enable for processor cores to run faster than the frequency specified by the manufacturer. The options are Disable and Enable . CPU HWPM State Control Enable CPU HWPM Select Enable for better CPU energy performance. The options are Disable , HWPM NATIVE MODE, and HWPM OOB MODE. Enable CPU Autonomous Cstate Use this feature to enable CPU Autonomous C State, which converts HALT instructions to Mwait. The options are Disable and Enable.
CPU C State Control CPU C State Use this feature to enable the enhanced C State of the CPU. The options are Disable and Enable . Package C State Limit This feature allows the user to set the limit on the C State package register. The options are C0/C1 State, C2 State, C6 (Non Retention) State , and C6 (Rentention) state. CPU C3 Report Select Enabled to allow the BIOS to report the CPU C3 State (ACPI C2) to the operating system. During the CPU C3 State, the CPU clock generator is turned off. The options are Disable and Enable . 61