S UPER S ERVER 6040 Manual 5-4 FCPGA Processor Installation When handling the FCPGA processor package, avoid placing direct pressure on the label area of the fan. ! This section covers the installation procedure for FCPGA (Flip Chip Plastic Grid Array) type processors. You should install the processor first and then install the motherboard in the chassis. Following the installation proce- dures in the order they appear in this section should eliminate the most common problems encountered when installing a system. IMPORTANT: Always connect the power cord last and always re- move it before adding, removing or changing any hardware compo- nents.
Heat Sink Follow the instructions that came with your processor or heat sink to attach a heat sink to the processor. Your heat sink should have a 3-pin fan, which connects to the CPU FAN header. Make sure that good contact is made between the CPU chip (the die) and the heat sink. Insufficient contact or improper types of heat sinks, thermal compound, and fans can cause the processor to overheat, which may crash the system. (You can check the CPU temperature readings in the "Periperal Setup" Section of BIOS.) Processor Your motherboard has two 370-pin sockets, which support Intel FCPGA processors.
Lift the lever on the FCPGA socket and insert the processor with the notched corner oriented toward pin one on the socket. Make sure the processor is fully seated in the socket and and then close the lever. You can also install a single 370-pin FCPGA CPU in CPU Socket 1 (see Pg. 5-10) without changing any jumper settings. See Figure 5-3 for views of the 370-pin FCPGA socket before and after processor installation. Mounting the Motherboard in the Chassis All motherboards have standard mounting holes to fit different types of chassis. Make sure the location of all the mounting holes for both the motherboard and the chassis match.
Although a chassis may have both plastic and metal mounting fasteners, metal ones are highly recommended because they ground the motherboard to the chassis. Make sure the metal standoffs click in or are screwed in tightly. Then use a screwdriver to secure the motherboard onto the motherboard tray. 5-6