Supermicro SuperServer 6040 — Supermicro SuperServer 6040 User's Manual PDF – 4U Dual Processor Server Guide

S UPER S ERVER 6040 Manual 5-5 Installing DIMMs ! Exercise extreme care when installing or removing DIMM modules to prevent any possible damage. Also note that the CAUTION memory is interleaved to improve performance (see step 1). DIMM Installation (See Figure 5-4) 1. Insert either two or four DIMMs as required for the desired system memory. Two-way interleaved memory requires that memory modules be installed in pairs(-first in the two slots of Bank0 and then in both slots of Bank1, ifneeded). 2. Insert each DIMM module vertically into its slot. Pay attention to the two notches along the bottom of the module to prevent inserting the DIMM mod- ule incorrectly. 3.

Gently press down on the DIMM module until it snaps into place in the slot. Repeat for all modules (see step 1 above). Support The 370DE6 only supports ECC registered SDRAM memory. PC133 and PC100 memory are both supported at their respective speeds. However, the memory speed is synchronized with CPU's front side bus speed. Therefore, the FSB of the CPU will determine the memory speed. Figure 5-4. DIMM Installation PC100 Notches PC100 Notches Note: Notches should align with the receptive points on the slot To Install: Insert module vertically and press down until it snaps into place. Pay attention to the notches. 5-8 CPU FSB 133MHz 100MHz Memory Module PC133 PC133/PC100 DIMM DIMM Slot