S UPER S ERVER 6040 Manual Extra Rack Unit Retention Screw (2) Control Panel Top Cover Thumbscrew (2) System LEDs Main Power Alarm Reset Slim CD-ROM Drive Floppy Drive System Reset S UPERMICR R SuperServer 6040 ALARM RESET Power Supplies Dummy(Empty) Module Rack Unit Retention Screw (2) (Upgradeable to a triple SCSI Drives Redundant Power Supply) Figure 6-1. Chassis Front View 6-2 Control Panel The control panel (located on the front of the chassis) must be connected to the JF1 connector on the motherboard to provide you with system status and alarm indications. A ribbon cable has bundled these wires together to simplify the connection.
Connect the cable from JF1 on the motherboard (making sure the red wire plugs into pin 1) to JP9 on the Control Panel PCB (printed circuit board). Pull all excess cabling out of the airflow path. The LEDs inform you of system status. See Chapter 3: System Interface for details on the LEDs and the control panel buttons. Figure 6-2 shows the connections, jumpers and indicators located on the control panel PCB. Details on JF1 can be found in the Chapter 5: Advanced Motherboard Installation. 6-2