Chapter 5: Advanced Serverboard Setup Universal Serial Bus (USB) Three Universal Serial Bus headers provide six USB connections on the baseboard (USB 0/1, 2/3, 6/7). Additionally, two Type A USB connectors (USB4, USB5) are also located on the board (cables not included). Refer to the tables on the right for pin defi nitions. (NC= No Connection) Chassis Intrusion A Chassis Intrusion header is located at JL1 on the system board. Attach an appropriate cable from the chassis to be informed of possible chassis intrusion when the chassis is opened. Internal Speaker The internal speaker, located at SP1, can be used to provide audible indications for various beep codes.
See the table on the right for pin defi nitions. 5-21 Type A USB (USB4/5) Pin Defi nitions Pin# Defi nition 1 +5V 2 PO- 3 PO+ 4 Ground 5 NA Backplane Accessible (USB0/1, 2/3, 6/7) USB Connectors Pin Defi nitions USB0/2/6 USB1/3/7 Pin# Defi nition Pin# Defi nition 1 +5V 1 +5V 2 PO- 2 PO- 3 PO+ 3 PO+ 4 Ground 4 Ground 5 NC 5 Key Chassis Intrusion Pin Defi nitions Pin# Defi nition 1 Intrusion Input 2 Ground Internal Speaker Pin Defi nition Pin# Defi nitions Pin 1 Pos. (+) Beep In Pin 2 Neg. (-) Alarm Speaker