Supermicro 8048B-TR4FT — Supermicro 8048B-TR4FT Server User & Service Manual PDF

SUPERSERVER 8048B-TR4FT USER'S MANUAL BMC Enable Jumper JPB1 allows you to enable the BMC controller on the X10QBi-A I/O module for IPMI/KVM support. The default setting is Normal. Refer to the table on the right for jumper settings. VGA Enable Jumper JPG1 allows the user to enable the onboard VGA1/2 ports on the X10QBi-A I/O module. The default setting is Enabled. See the table on the right for jumper settings. TPM Enable Jumper JPT1 allows the user to enable TPM (Trusted Platform Module) support to enhance data security. The default setting is Enabled. See the table on the right for jumper settings.

Watch Dog Enable/Disable Watch Dog (JWD1) is a system moni- tor that can reset the system when a software application hangs. Close pins 1-2 to reset the system if an applica- tion hangs. Close pins 2-3 to generate a non-maskable interrupt signal for the application that hangs. Refer to the table on the right for jumper settings. The de- fault setting is Reset. Watch Dog must also be enabled in the BIOS. LAN Enable/Disable JPL1 enables or disables the LAN Port1/ LAN Port2 on the X10QBi-A I/O module. Refer to the table on the right for jumper settings. The default setting is Enabled.

5-26 BMC Enable/Disable Jumper Settings Jumper Setting Defi nition Pins 1-2 BMC Enable Pins 2-3 Normal VGA Enable/Disable Jumper Settings Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled TPM Enable/Disable Jumper Settings Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled Watch Dog Jumper Settings Jumper Setting Defi nition Pins 1-2 Reset Pins 2-3 NMI Open Disabled LAN Enable/Disable Jumper Settings Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled